SPECIFICATIONS:
OUTPUT
Power……60W RMS per channel, 8ohms, 1KHz, <0.05% THD. 100W RMS per channel, 4ohms 1KHz, 0.05%THD.
Frequency Response……20Hz to 20KHz, 0.5dB. Signal to Noise Ratio……106dB, 20Hz to 20KHz, Unweighted.
Minimum Load……4 ohms. Damping Factor…...>150 at 8 ohms. Slew Rate…… >20V/us
Connectors……5mm screw lock captive screw connector, 4 poles. Protection……Thermal, Clip, Output shorting.
INPUT
Sensitivity......+4dBu for full output. Impedance......>10K ohms balanced/unbalanced. Voltage Gain......24dB.
Max. Input level......+21dBu. Channel separation......>78dB. CMMR......>80dB. Control......Each channel by trimmer pot.
Connectors...... Balanced via RJ45 screened connector (In / Out for other units connection), Unbalanced via RCA connector.
POWER
Mains requirements ......100 VAC to 240VAC 50/60 Hz. Mains socket……Standard IEC
Typical consumption……40 Watts at 1/4 power, 8 ohms. Quiescent…… 8 Watts Standby......<3W
CONTROL / REMOTE / INDICATIONS
Control/ Input port……RJ-45 socket, connection by CAT-5 screened cable. Mute......Pin 5 connected to ground (Pin 7)
Standby……Pin 4 connected to ground (Pin 7) or automatically after about 5 minutes without signal.
12VDC……For external devices as Hubs, Mixers, Players, etc. Maximum consumption 300mA.
Signal……Presence of signal input of at least -24dB. Limiter/Protect……LED indicator of clip limiting or thermal / short protection.
GENERAL
Structure……Metal case with convection aluminum heat sink cooling.
Mounting......1U rack or 1/2 with 2 short / long "ears". On wall & under table with 4 short "ears" (Supplied), table top with rubber legs.
Dimensions……H 4.4cm x W 21.6cm x D 19.2cm. (1/2 rack wide , 1U) Weight……Net = 1.2Kg, Shipping = 2.88Kg
Operating conditions……-10°C to +50°C Temperature, 10%-90% Humidity. MTBF……300,000 HOURS